:	Aug 23, 2005

.

Disconnect the battery ground cable.

.

Remove the engine cover.

.

: It is important to twist the spark plug wire boot while pulling upward to avoid possible damage to the spark plug wire. :   Note the fitted position. Disconnect the high tension (HT) electrical connectors.

.

: Eye protection must be worn. :   Use compressed air to remove any foreign material from the spark plug wells. Clean the area surrounding the spark plugs.

.

Remove the spark plugs.

.

: Prior to fitting new copper spark plugs, check that the electrode gaps are set to 1.4 mm, adjust if necessary. Existing platinum or copper spark plugs must not be re-gapped in service; if the electrode gap is incorrect new spark plugs must be fitted. :   Do not apply lubricant to the threads. Install the spark plugs.   Check the spark plug gap, refer to specifications.   Tighten the spark plugs to 18 Nm (13 lb.ft).

.

: Install spark plug wires to postions noted on removal. Do not cross wires. Connect the HT electrical connectors.   Apply silicone grease to inside of spark plug boot.

.

Install the engine cover.

.

Connect the battery ground cable.